Výrobce: SHURE
Model: SHURE VP 88
Dostupnost: cca 14 dní
Cena: 33 711Kč
Bez daně: 27 860Kč

Stereofonní kondenzátorový mikrofon. Díky unikátnímu snímání systémem midl-side je sterofonní záznam z tohoto mikrofonu mono kompaktibilní.

User quide

The Shure Model VP88 is a single-point, stereo condenser microphone for use in professional studio recording, field production, electronic news gathering (ENG), and studio broadcasting applications. It combines two condenser cartridges in a single housing to create a stereo audio image of the sound source. It is unique in its ability to capture the realism of a live event and yet withstand rigorous field production environments.

One cartridge (Mid) faces forward to capture on-axis sound using a cardioid pickup pattern. The other cartridge (Side) is bi-directional, capturing sound from either side. The VP88 contains an internal M-S matrix with three settings for different degrees of stereo image separation. The internal matrix can be bypassed if an external matrix is used or if stereo imaging is done in post-production.

  • VP88 - Includes "Y-splitter" cable, foam windscreen, stand adapter, 6V battery and zippered storage bag. Phantom power or included battery required.
  • Time-coherent, Mid-Side (M-S) design for optimal stereo imaging
  • Built-in stereo matrix for direct control of the stereo spread; direct M-S outputs available
  • Mono compatibility ideal for broadcast applications
  • 40 to 20,000 Hz frequency response
  • Low noise and distortion
  • Wide dynamic range
  • Switch-selectable, low-frequency rolloff (12 dB/octave below 80 Hz) for reduced pickup of ambient noise & stand vibration
  • Operates on phantom power or a 6V camera battery
  • LED power indicator
  • Internal shock mount for reduced stand vibration and handling noise
  • Built-in "pop" screen
  • Includes windscreen, swivel adapter, and Y-cable
Single-point stereo (MS configuration) condenser
Frequency Response
40 to 20,000 Hz
Polar Pattern
Mid Cartridge: Cardioid (unidirectional)
Side Cartridge: Bidirectional
Output Impedance
Rated at 150 (100 ohms actual). Recommended minimum load impedance: 800 ohms (may be used with loads as low as 150 ohms with reduced clipping level)
Sensitivity (1 kHz, MS mode)
Open Circuit Voltage: -66 dB (0.5 mV) Mid. (Side level 1.6 dB higher than Mid level) (0 dB=1 V/Pa)
Side Level (Stereo mode; relative to Mid level)
Low: -6.0 dB; Medium: -1.9 dB; High: +1.6 dB
Clipping Level (1 kHz)
800 ohm Load (less than 1% THD)
-12 dBV (0.25 V)(Mid output, 1% THD)
-10 dBV (0.30 V)(Side output, 1% THD)
150 ohm Load (less than 3% THD)
-25 dBV (0.06 V)(Mid output)
-19 dBV (0.11 V)(Side output)
Maximum SPL
800 ohm Load: 129 dB
150 ohm Load: 119 dB
Hum Pickup
-4 dB equivalent SPL in 1 millioersted field (60 Hz)
Self Noise (Mid, Side, Left and Right outputs; equivalent sound pressure levels)
24 dB typical, A-weighted
28 dB typical, weighted per DIN 45405
Dynamic Range
105 dB (maximum SPL to A-weighted noise level)
Signal-to-Noise Ratio*
70 dB (IEC 651) at 94 dB SPL
*S/N ratio: difference between microphone output at 94 dB SPL and microphone self-noise A-weighted.
Overvoltage Protection
Maximum External Voltage applied to Pins 2 through 5 with respect to Pin 1: +/- 75 Vdc
Positive pressure applied from any direction to the Mid cartridge or from the left to the Side cartridge in the MS mode, or applied from the front in the Stereo mode produces positive voltage on pin 2 relative to pin 3 (Mid/Left) and pin 4 relative to pin 5 (Side/Right).
Supply Voltage: 9 to 52 Vdc
Current Drain: 1.3 mA/output; 2.6 mA total
Type: 6 V cylindrical*
Life: 70 hours**
Current Drain: 2.4 mA total
*Silver oxide (NEDA 1406SOP), lithium (NEDA 5005L), alkaline (NEDA 1414A)
**Fresh silver oxide or lithium battery; 40 hours with alkaline
Environmental Conditions
Operating: -18 to 57 degrees C (0 to 135 degrees F) (Relative Humidity <90%)
Storage: -29 to 74 degrees C (-20 to 165 degrees F) (Relative Humidity <80%)
Y-Splitter Cable (supplied): 0.76 m (30 in.) vinyl-jacketed, dual? shielded, 2-conductor with 5-pin female XLR connector on microphone end and two 3-pin male XLR connectors on equipment ends.
Microphone Extension Cable (Model C110; optional): 7.6 m (25 ft.) vinyl-jacketed, shielded, 4-conductor with 5-pin male XLR connector on one end and 5-pin female XLR connector on other end.
Brass and nickel-plated aluminum construction with stainless steel grille. Finished in satin black vinyl enamel
See User Guide
Net Weight
417 grams (14.7 oz) less battery and cable


Napsat recenzi

Vaše jméno a příjmení:

Vaše recenze: Poznámka: HTML tagy nebudou převedeny!

Hodnocení: Nejhorší            Nejlepší

Opište prosím kód z obrázku do pole níže:

Tento e-shop je umístěn na serveru ELEKTROAKUSTIKA.CZ. Používá se opensource systém OpenCart